HONDA 2011 CR-Z - Owner's Manual User Manual

Page 61

Safe Driving

Child Safety Safety of Infants and Small Children

Installing a Child Seat

■

1. Move the passenger seat to the rearmost

position.
Place the child seat on the passenger seat.

Route the seat belt through the child seat

according to the seat maker’s instructions,
and insert the latch plate into the buckle.

Insert the latch plate fully until it clicks.

4. Slowly pull the shoulder part of the belt all

the way out until it stops. This activates the
lockable retractor.
Let the seat belt wind up to remove the

slack and then try to pull it out to make
sure it is locked and does not come out.

If you are able to pull the shoulder

belt out, the lockable retractor is not
activated. Pull the seat belt all the way
out, and repeat steps 3 – 5.

6. Grab the shoulder part of the seat belt

near the buckle, and pull up to remove any
slack from the lap part of the belt.

When doing this, place your weight

on the child seat and push it into the
vehicle seat.

Installing a Child Seat

All child seats must be secured to the vehicle with
the lap part of a lap/shoulder belt.

For your child's safety, when using a child seat
installed using the vehicle's seat belt system, check
that the seat is properly secured to the vehicle.

31SZT600book.indb 60

2010/04/28 13:40:40

TOC

Home

Index

QRG

2011 CR-Z