HONDA 2012 Pilot - Navigation Manual - Manual (Page 54)

Navigation System 53
PILOT KA 31SZA830
Driving to Your Destination
Changing the Route Preference
The system lets you select the way you
want to drive to your destination. Select
Route Pref. on the Calculate route to
screen by rotating the
Interface Dial
knob.
• You can choose
MAX or MIN for
three settings: Freeways, Toll
Roads, and Ferries. The route
calculations for the current selection
will be displayed in the upper right-
hand corner of the screen.
The generated route may not be the
route you would choose. For safety
reasons, the system generally applies the
following rules to your route:
• Shortcuts through residential areas
are avoided.
• Right turns are favored over left turns
or U-turns.
• Restricted turns (turns that cannot be
made during or at certain times of the
day) are not used.
Viewing the Routes
If you select
View Routes on the
Calculate route to screen, you can
view three possible routes to your
destination. You can also use the
Interface Dial to verify the areas
peripheral to the map. If you select
View Routes, the display changes to:
These different routes are shown and
calculated based on the setup options in
Route Pref..
You can select one of the three routes
(1-3) by rotating the
Interface Dial
knob. The system will calculate the
selected route and display the
map
screen.
NOTE:
• The driving distance and time
estimated for the various routes is
displayed.
• It is not unusual for the different
methods to pick the same route. Voice
commands cannot be used while the
system is calculating.
• Zoom IN/OUT to view route details
or traffic conditions is not available
on the
View routes screen. After
moving the Interface Dial and
scrolling through the map, you can
then zoom in or out on the
map
screen to view your route in details.
00 PILOT_KA-31SZA830.book 53 ページ ２０１１年７月２４日 日曜日 午後５時１４分