GTCO DrawingSlate I & II Commands - Manual (Page 8)

Tablet can respond to 2x00 commands in the 2000/9100 subsets.
2000 Commands (2x00)
NOTE: Use commands below only when in 2000 mode/formats. Can be inhibited by one
byte enable menu bit.
@Track mode 1 pps
A track mode 5 pps
B track mode 10 pps
C track mode 20 pps
D track mode 40 pps
E track mode 75 pps
F track mode 100 pps
G track mode 125 pps
H run mode 1 pps
I run mode 5 pps
J run mode 10 pps
K run mode 20 pps
L run mode 40 pps
M run mode 75 pps
N run mode 100 pps
O run mode 125 pps P point mode
Q point prompt mode
R run prompt mode
S halt or stop mode
T track prompt mode
MM and 2000 Commands
NOTE: Commands work in both mm and 2000 mode/formats. Do not write drivers using
these to be 2x00 and 9x00 compatible. Commands below can be inhibited by the one byte
enable menu bit.
a
b
c
Send size.
Set origin to upper left.
Set origin to lower left. On 6x9, b set vertical and c set horizontal.
d
e
f
g
h
100 lpi
200 lpi
10 lpmm
400 lpi
400 lpi i
j
k
l 20 lpmm
1000 lpi
1270 lpi (2x00 mode only)
1 lpi n
o
p
q 2 lpi
50 lpmm (1270 lpi)
4 lpi
40 lpmm
MM Commands
NOTE: Use below commands only when in mode/formats. Can be inhibited by the one
byte enable menu bit.
nul
Reset (only in MM formats). Note the nul reconfigure in tablet a.