GTCO DrawingBoard V - Quick Start Guide - Manual (Page 3)

USB Connection – With TabletWorks CD Only –
1. Connect the corded transducer – cursor or pen – to the appropriate jack on the
digitizer’s Connector Panel. The connector is keyed and will fit only the correct jack.
Do not force it.
2. Attach the USB interface cable to the USB jack on the DrawingBoard V Connector
Panel. The connector is keyed and will fit only the correct jack. Do not force it.
3. Join the other end of the USB cable to any one of the USB ports on your
computer or USB hub. Turn the power switch on. The digitizer will beep once,
indicating it has power.
NOTE: Power is supplied through the USB port. No additional power source is needed for
a USB installation, unless you are using DrawingBoard V with a corded high-accuracy
cursor. For that configuration only, connect the power supply before making the USB
connection.
4. If Windows displays the Found New Hardware prompt, follow the onscreen
instructions to finish the Found New Hardware process.