Great Planes U-Can-Do 3D EP ARF - GPMA1275 - Manual (Page 9)

❏
5. Cut a slot in the left elevator half in the location shown.
The front of the slot is even with the start of the hinge bevel
on the elevator.
❏
6. Cut a slot in the rudder in the location shown. The front of
the slot is even with the start of the hinge bevel on the rudder.
❏
7. Cut a slot in each aileron in the location shown. The
front of the slots are even with the start of the hinge bevels
on the ailerons.
❏
8. Press a plastic z-bend clevis into each of the four
control horns.
❏
9. Glue a control horn into the underside of the elevator half.
❏
10. Secure the back side of the control horn with a control
horn retainer. Secure it with a small bead of glue.
Elevator Cross Section
Elevator Leading Edge
Bevel
Slot
9