Great Planes SU-31 Sukhoi EP 3D ARF - GPMA1547 - Manual (Page 13)

13
o 4. Attach the landing gear to the fuselage using four 3 x 8mm
machine screws, four 3mm washers, and threadlocking
compound. Adjust the wheel spats so that they sit parallel
with the wing and fuselage.
o 5. Remove the covering from the tab portion of the tail
skid. Use a hobby knife to cut open the covering over the slot
in the bottom tip of the tail skid. Glue a 3mm washer into the
slot. The washer will prevent the tail skid from being worn
down when flying from a paved runway.
o 6. Trim the covering from the tail skid slot at the aft end
of the fuselage. Glue the tail skid into the slot using medium
CA or epoxy.
MOUNT THE MOTOR, ESC & RECEIvER
o 1. Install four 3mm blind nuts to the back of the motor mount.
The back of the motor mount does not have any writing on it. If
you are installing a non-ElectriFly motor you may need to drill
different holes and install the blind nuts in those.