Great Planes Stuka Ju-87 60 ARF - GPMA1340 - Manual (Page 10)

❏ ❏
23. On the bottom of the wing, cut away the covering
from the two servo bays and the landing gear mounting rails.
❏ ❏
24. Cut away the covering in the top of the wing to
reveal the holes that the servo leads come through. After
cutting the hole, feed the string from inside of the wing
through the hole. This will allow you to pull the servo leads
through the wing after the two wing halves are joined.
❏
25. Repeat steps 2 to 24 for the left wing panel.
❏
26. Locate the plywood center wing joiner. Test fit it into
the right and left wing halves. When fitting it into the wing,
make sure that the joiner angles downward.
❏
27. When you are satisfied that the two wing halves fit
well together, apply a liberal amount of 30-minute epoxy to
the joiner, the joiner box and the wing root ribs. Insert the
wing joiner into one of the wings and then install the
opposite wing onto the other end of the wing joiner. Put a
clamp onto the tab that extends forward from the center of
the wing and use masking tape to hold the wings together
while the glue is curing.
10