Great Planes Pluma 3D Bipe ARF ARF - GPMA1130 - Manual (Page 4)

ADDITIONAL ITEMS REQUIRED
Required Hardware & Accessories
This is the list of adhesive and building supplies required
to fi nish the Pluma 3D ARF. Order numbers are provided
in parentheses.
❏
1 oz. [30g] Thin Foam-Safe CA (HOTR1040)
❏
1 oz. [30g] Thick Foam-Safe CA (HOTR1050)
❏
1 oz. [30g] Medium Foam-Safe CA (GPMR6069)
❏
1/2 oz. [15g] Thin Pro ™ CA (GPMR6001)
❏
1/2 oz. [15g] Medium Pro CA+ (GPMR6007)
❏
Drill bits: #57 [1mm], 1/16" [1.6mm]
❏
#1 Hobby knife (HCAR0105)
❏
#11 Blades (5-pack, HCAR0211)
❏
Hobbico ® steel T-pins 1" (100) (HCAR5100)
❏
Great Planes Pro Threadlocker (GPMR6060)
❏
CA applicator tips (HCAR3780)
❏
150-grit Sandpaper
❏
Bru Line hemostat – curved 5-1/2" (BRUR1303)
❏
Hobbico fl exible 18" ruler stainless steel (HCAR0460)
❏
Builder’s triangle set (HCAR0480)
❏
2 oz. [57g] Spray CA activator (GPMR6035)
Optional Supplies & Tools
Here is a list of optional tools mentioned in the manual that
will help you build the Pluma 3D ARF.
❏
Great Planes double-sided servo tape 1" x 3' (GPMQ4442)
❏
Panel Line Pen (TOPQ2510)
❏
Denatured alcohol
❏
Rotary tool such as Dremel ® with cutoff wheel
❏
PolyCharge4 ™ LiPo battery charger (GPMM3015)
❏
Hobbico 12 Volt DC power supply (HCAP0250)
❏
Equinox ™ 1 to 5 cell LiPo cell balancer (GPMM3160)
IMPORTANT BUILDING NOTES
• When you see the term test fi t in the instructions, it
means that you should fi rst position the part on the assembly
without using any glue, then slightly modify or custom fi t
the part as necessary for the best fi t.
• Whenever the term glue is written you should rely upon
your experience to decide what type of glue to use. When
a specifi c type of adhesive works best for that step, the
instructions will make a recommendation.
• Photos and sketches are placed before the step they
refer to. Frequently you can study photos in following steps
to get another view of the same parts.
• The stabilizer and wing incidences and motor thrust
angles have been factory-built into this model. However,
some technically-minded modelers may wish to check these
measurements anyway. To view this information visit the web
site at www.greatplanes.com and click on “Technical Data.”
Due to manufacturing tolerances which will have little or no
effect on the way your model will fl y, please expect slight
deviations between your model and the published values.
4