Great Planes Pluma 3D Bipe ARF ARF - GPMA1130 - Manual (Page 16)

16
❏
4. Apply several generous beads of medium or thick foam-
safe CA to the back side of the landing gear doubler (the side
you just sanded). Center the doubler over the holes in the
bottom of the lower wing and glue it in place.
❏
5. Locate the two pre-assembled landing gear legs and
the two foam wheel pants. You should have a right and a left
side of each of these.
❏
6. Use medium or thick foam-safe CA to attach the wheel
pants to the landing gear legs.
❏
7. Slide each landing gear leg though the holes provided
in the wing. They will go through the wing holes fi rst, then the
fuselage side, and then cross over to the opposite fuselage
side. Rotate the landing gear rod until the wheels point
straight ahead. Glue the landing gear in place.
❏
8. Mount the recommended propeller using a prop saver
O-ring. Please see the “Motor, Propeller, Battery, & ESC
Recommendations” section on page 3 of this manual to
match the correct prop to your motor.
❏
9. With the hook and loop material that you have left over,
separate the hook side from the loop side and stick the hook
side (bristly side) inside the fuselage. Apply the remaining
loop material to your battery packs.