Great Planes Extra 330SC EP ARF - GPMA1129 - Manual (Page 12)

12
❏
19. Insert the aileron servo in the fuselage. Center the
aileron servo trims and attach the servo arm to the servo
using the servo screw. Note the direction of the anti-differential
arm. The angle is the same as the aileron hinge line.
❏
20. Use foam safe CA to glue the aileron servo to the
fuselage.
❏
21. Insert the z-bend of both aileron pushrods in the
anti-differential arm.
❏
22. Insert an aileron control horn onto each end of the
aileron pushrods. Insert the control horns in the slot of the
ailerons. Center the aileron trim on the transmitter. Check
that the ailerons are centered. If they are not, adjust the
length of the pushrods as needed. Then, glue the aileron
control horns in the ailerons, adjust the pushrods and apply
a drop of thin CA to the end of the heat shrink tubing.
INSTALL THE MOTOR
❏
1. Install the motor to the motor mount using the included
#2 x 3/8" [9.5mm] self tapping screws.
❏
2. Place a small piece of loop (soft) side of the self
adhesive hook and loop material to the back of the
ESC and the receiver.
❏
3. Place a piece of hook (rough) material under the
fuselage, close to the front. Route the motor leads through
the fuselage and connect them to the motor. Attach the
ESC to the loop material.