Great Planes Easy Sport 40 ARF MonoKote - GPMA1036 - Manual (Page 7)

7
❏
1. Lay the 1/8” [3.2mm] ply aileron servo tray on the
bottom of the wing. Center the tray over its mounting area
and draw a line on the covering around it using a felt-tip
marking pen.
❏
2. Remove the covering inside the lines with a hobby
knife, being careful not to cut into the wood. Glue the servo
tray in place with 6-minute epoxy or medium CA.
❏
3. After the glue has cured, trim the wood inside the
servo tray. Trial fit the servo in the tray, trimming the tray
and wing as needed.
❏
1. Position the 1/8” [3.2mm] ply wing bolt plate 1/4”
forward of the trailing edge of the top of the wing. Use the
centerline on the wing bolt plate to center it on the centerline
of the wing. Draw a line around the plate on the covering using
a felt-tip pen. Remove the covering inside the lines with a
hobby knife, being careful not to cut into the wood.
❏
2. Glue the wing bolt plate in position with 6-minute
epoxy or medium CA.
❏
3. Turn the wing over and remove the covering from the
holes for the wing bolts. Using a 1/4” [6.4mm] drill bit, drill
holes through the wing bolt plate for the wing bolts.
Note: The following steps depict the installation of a 2-stroke
engine. The steps are similar if you are using a 4-stroke
engine, although some changes to the throttle pushrod
routings will need to be made.
❏
1. Remove the center spreader from the engine mount
halves. Trim any excess flashing with a hobby knife or file.
❏
2. This is a good time to fuelproof the engine
compartment. Lightly brush a mixture of 30-minute epoxy
thinned with isopropyl alcohol into the engine
compartment. Be careful not to get any of the epoxy into
the blind nuts that are located in the firewall.
Install the Engine
INSTALL FUSELAGE COMPONENTS
Install the Wing Bolt Plate
Install the Aileron Servo Tray