GME GX600 - Manual (Page 9)

GX600A INSTRUCTION MANUAL PAGE 9
DC CONNECTIONS
Connect the RED power lead to the Positive (+) side of the
battery or to an accessory point in the vessel’s fuse box.
Connect the BLACK power lead to the Negative (-) side of
the battery or to a ground point in your vessel’s fuse box.
NOTE: The RED power lead is fitted with a 10 amp fuse. If
the fuse blows, use only a standard 10 amp (3AG type) fuse
as a replacement. Use of higher rated fuses or ‘slow blow’
types could result in damage to your radio which would
void the warranty.
Connect the antenna cable to the rear antenna socket
on the radio using a PL259 coaxial connector.
If required, an SPK600 extension speaker may be
installed near the steering position or outside the
cabin to improve the reception clarity in those areas.
The SPK600 is specifically designed for the GX600A
with a water tight connector to match the extension
speaker socket on the rear of the radio.
NOISE SUPPRESSION
The inherent design of VHF FM radios results in a high
level of resistance to ignition and electrical interference.
However in some installations it may be necessary to
take additional steps to help reduce or eliminate noise
interference. During installation, try to route the DC battery
leads, the antenna lead or any accessory wires away from
the engine compartment, ignition or alternator wiring. If the
noise continues, it may be necessary to fit a suppression kit.
Contact your local marine dealer for more information.
Similarly, if the interference you are experiencing is from
other electronic equipment such as a depth sounder, try to
keep the depth sounder’s DC leads and transducer cable
well away from your GX600A’s wiring.
GX600A WIRING
DC Power Cable Extension Speaker Socket
Gimbal Knob
Antenna Socket
Mounting Bracket
Rear Panel Connections
Extension Speaker
SPK600 (optional)
VHF Antenna
10 Amp Fuse
Black - Red +
12 Volt
Battery
GX600A