beautypg.com

Radio, Am-fm radio, Radio -6 – GMC 2012 Canyon User Manual

Page 148: Vehicle checks -4, Am-fm radio -6, Extended

background image

Black plate (6,1)

GMC Canyon Owner Manual - 2012

7-6

Infotainment System

LOC (Locked): This message
displays when the THEFTLOCK

®

system has locked up. Take the
vehicle to your dealer for service.

If any error occurs repeatedly or if
an error cannot be corrected,
contact your dealer.

Radio with CD (MP3/WMA)

CAL ERR (Calibration Error): The
audio system has been calibrated
for the vehicle from the factory.
If CAL ERR displays it means that
the radio has not been configured
properly for the vehicle and it must
be returned to your dealer for
service.

LOCKED: This message displays
when the TheftLock

®

system has

locked up. Take the vehicle to your
dealer for service.

If any error occurs repeatedly or if
an error cannot be corrected,
contact your dealer.

Radio

AM-FM Radio

Finding a Station

AM-FM Radio

AM FM: Press to switch between
FM1, FM2, or AM.

TUNE : Turn to select radio
stations.

o

SEEK: Press to go to the

previous station and stay there.

To scan stations, press and
hold

o

SEEK for two seconds

until a beep sounds. The radio
goes to a station, plays for a few
seconds, then goes to the next
station. Press

o

SEEK again to

stop scanning.

To scan preset stations, press
and hold

o

SEEK for more than

four seconds until two beeps sound.
The radio goes to the first preset
station, plays for a few seconds,
then goes to the next preset station.
Press

o

SEEK again to stop

scanning presets.

SEEK

p

: Press to go to the next

station and stay there.

To scan stations, press and hold
SEEK

p

for two seconds until a

beep sounds. The radio goes to a
station, plays for a few seconds,
then goes to the next station. Press
SEEK

p

again to stop scanning.

To scan preset stations, press and
hold SEEK

p

for more than

four seconds until two beeps sound.
The radio goes to the first preset
station stored on the pushbuttons,
plays for a few seconds, then goes
to the next preset station. Press
SEEK

p

again to stop scanning

presets.