GIN Yeti xtrem - Manual (Page 14)

14
Before you fly
Make sure your dealer has checked the harness for completeness and basic settings. Your
harness must be assembled by a suitably qualified paragliding professional, for example, your
instructor.
Gin Gliders recommend that assembly be carried out in the following order. If you are in any
doubt whatsoever about this procedure, please seek professional advice from your instructor,
GIN dealer or importer.
Installing the speed system
Assemble the speed system from bottom to top. Pass the cord of the speed bar through the
speed ring located on the bottom edge of the harness seat. Route the cord up through the pulley
and tie it to the speed connector.
CAUTION: Make sure that the speed
system is not too short. The front
risers of your paraglider must not
be pulled down in normal (unaccel-
erated) flight.
1 2