FXpansion EtchRed - Manual (Page 11)

Etch audio modules and signal path 11
© 2012 FXpansion Audio
2.3 Output
F1 Out, F2 Out
The F1 Out and F2 Out parameters set the level of the audio leaving
each of the 2 filters, useful for attenuating or boosting each signal after
filtering.
Comp (Compress)
The Output section features a simple single-control compressor,
switchable between a soft and hard knee response.
The Compress parameter sets the amount of compression applied to
the signal. At the minimum setting, no compression is applied and the
signal passes through to the Output module without being processed.
Hard (Hard-knee)
By default, Etch Red's compressor features soft-knee behaviour. With the Hard button activated,
the compressor behaves with hard-knee characteristics.
Level [ w /Tra n sM od a m ou n t]
The Level control sets the final level of the audio leaving Etch Red, useful for any final attenuation
or boosting of the signal.
Mix [ w /Tra n sM od a m ou n t]
The Mix control sets the balance between the original input signal (towards the left of the control)
and the processed signal (towards the right of the control).