Philips CDI220/80P - Manual (Page 3)

Safety Precautions
WARNING: TO PREVENT FIRE OR SHOCK HAZARD. DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR
MOISTURE.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT, FULLY
INSERT.
LASER SAFETY: This unit employs a laser. Only a
qualified service person should remove the cover or
attempt to service this device, due to possible eye injury.
THIS DIGITAL APPARATUS DOES NOT EXCEED THE
CLASS В LIMITS FOR RADIO NOISE EMISSIONS FROM
DIGITAL APPARATUS AS SET OUT IN THE RADIO
INTERFERENCE REGULAUONS OF THE CANADIAN
DEPARTMENT OF COMMUNICAUONS.
CET APPAREIL NUMÉRIQUE N'ÉMET PAS DE BRUITS
RADIOÉLECTRIQUES DÉPASSANT LES LIMITES
APPLICABLES DANS LA RÈGLEMENT SUR LE
BROUILLAGE RADIOÉLECTRIQUES ÉDICTÉ PAR LE
MINISTÈRE DES COMMUNICATIONS DU CANADA.
ATTENTION: POUR EVITER LES CHOCS
ÉLECTRIQUE, INTRODUIRE LA LAME LA PLUS
LARGE DE LA FICHE DANS LA BORNE CORRE­
SPONDANTE DE LA PRISE ET POUSSER JUSQU'AU
FOND.
CAUTION: USE OF CONTROLS OR ADJUSTMENTS
OR PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIAUON EXPOSURE.
/ \
CLASSI
LASER PRODUCT
s /
NOTICE: This device incorporates an anticopy
process technology that is protected by U.S. patents
and other intellectual property rights. The anticopy
process is licensed for non-commercial, home use
only. Reverse engineering or disassembly is prohib­
ited.
WARNING:
This device complies with Part 15 of the FCC (U-S.A.) Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE:
This equipment has been tested and foimd to comply with the limits for a Class B digital device, pmrsuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation! This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving anterma.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is coimected.
— Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT:
This product was FCC certified under test conditions that included use of shielded cables and connectors between
system components. It is important that you use shielded cables to reduce the possibility of causing interference to
radios, television sets, and other electronic devices. If you have any problems, contact your dealer.
Any change or modifications to the equipment by the user not expressly approved by the grantee or manufacturer
could void the user's authority to operate such equipment.
NOTE TO CATV SYSTEM INSTALLER:
This reminder is provided to call the CATV (Cable-TV) system installer's attention to Article 820-40 of the NEC that
provides guidelines for proper groimding and, in particular, specifies that the cable groimd shall be coimected to the
groimdmg system of the binlding, as close to the point of cable entry as practical.
-3-