Operation, Windows 98 setup, Details on operation – Philips DSS 370 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
Operation
Windows 98 setup
1 Switch on the speakers using the POWER
button,
-► The power indicator goes on.
2
Switch on the subwoofer by turning the
VOLUME dial clockwise.
-► The power indicator goes on,
3
Adjust the sound using the VOLUME, DBB,
and INCREDIBLE SURROUND controls.
Details on operation
• The volume controls on the satellite speakers
can only be used if the USB is connected and
supported by the operating system.
• If the USB is connected, the speakers will
switch to standby while the computer is
turned off. When the computer is switched
on, the speakers will switch on too.
• Legacy DOS games do not support USB.
Sounds can only be played via a soundcard
that is connected to the LINE IN jack of the
speakers.
Use the following procedure if a soundcard is
installed on your Windows 98 system. This
should enable audio playback via the USB.
1
Choose the
Start
button in the task bar.
2
Point to
Settings
and choose
Control
Panel.
3
Double-click the
Multimedia
icon.
4
Select the
Audio
tab.
5
Under
Preferred device,
select
Philips
USB Audio Device.
6
Select the
Use only preferred device
check box on the bottom of the tab.
7
Choose the
OK
button.
a>
B