Philips CD 110 - Manual (Page 7)

ADDITIONAL INFORMATION
LISTENING WITH HEADPHONES (PHONES) TECHNICAL DATA
• Connect headphones with a 6.3 mm jack plug to
the PHONES socket.
- The sound level is adjusted with the VOLUME
control (CD 130/CD 140 only).
MAINTENANCE •
The CDs
• Never write on the printed side of a CD.
• Do not attach any stickers to the CD.
• Keep the shiny surface of the CD clean.
Use a soft lint-free cloth and always wipe the disc
in a straight line from centre to edge.
• Never use cleaning agents for conventional
records.
• Detergents orabrasive cleaning agents should not
be used either.
The player
• A chamois leather slightly moistened with water is
sufficient for cleaning the player.
• Do not use cleaning agents containing alcohol,
spirits, ammonia or abrasives.
• The lens of the laser (Fig. S) should not be
cleaned.
FAULTS AND THEIR LIKELY CAUSES__________
If a fault occurs, mn through the points listed below
before faking your player for repair. Check whether:
- condensation has formed on the lens of the laser
due to a dramatic change in temperature; this will
disappear automatically after some time;
- the CD has been inserted correctly with the printed
side up and that there is a CD in the compartment;
- the CD is dirty, badly scratched or warped;
- the player has been connected to the PHONO
socket of the amplifier.
If the fault remains, try to clear it by switching the
player off and on again:
• Remove the mains plug from the wall socket.
• Insert the mains plug in the wall socket again.
If this also falls to help, consult your dealer.
Under no circumstances should you repair the
player yourself, as this will invalidate the gua-
ranteel
Typical Audio Performance
Frequency range: 2-20,000 Hz
Amplitude linearity: 0.02 dB
Phase linearity: 0.5° (20-20,000 Hz)
Dynamic range: 86 dB
Signal-to-noise ratio: 95 dB (A-weighted)
Channel separation: 94 dB
Total harmonic distortion: 0.015% (1 kHz)
D/A conversion; quadruple oversampling
(176.4 kHz) with digital filter and two 16-bit D/A-con-
verters
Audio output level: 2
Impedance PHONES socket: 8-1000 ohms
Power supply
Mains voltage and frequency: see the type plate on
the rear of the player
Power consumption:
- 10 W in PLAY mode
- 7 W in STAND BY mode
Safety requirements: lEC
Cabinet
Maferial/finish: metal and polystyrene with decorati­
ve trim
Dimensions (w x h x d): 360 x 100 x 280 mm
Weight: 2.7 kg approx.
Subject to modification
This Compact Disc player complies with radio
interference requirements as laid down in EC
regulations.