Switching on and off, Adjusting volume and sound, Improving radio reception – Philips AZ 1203 User Manual

Page 7: Basic functions

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

BASIC FUNCTIONS

Switching on and off

Set the POWER slider to the desired sound source:

CD, TUNER, or TAPE.

The set is switched off when the POWER slider is in position

OFF/TAPE and the keys of the tape deck are released.

Note: If you run the set on batteries, always be sure to switch the

set off after use. This will avoid unnecessary power

consumption.

Adjusting volume and sound

Adjust the volume using the VOLUME control.

Display indication: Volume level from 0 to 32 (AZ1208 only).

Increase and decrease the bass level by pressing DBB.

The bass level can also be emphasised if you place the set against

a wall or shelf. Do not cover any vents and leave sufficient room

around the unit for ventilation.

improving radio reception

For

stations, pull out the telescopic antenna. To improve the

signal, incline and turn the antenna. Reduce its length if the signal

is too strong (very close to a transmitter).

For

and

stations, direct the built-in antenna by turning the

whole set. The telescopic antenna is not needed.

This manual is related to the following products: