Troubleshooting warning, Problem possible cause solution – Philips AZ 1203 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING
WARNING
Under no circumstance should you try to
repair the set yourself as this will
invalidate the guarantee.
If a fault occurs, first check the points listed
below before taking the set for repair.
If you are unable to solve a problem by
following these hints, consult your dealer or
service center.
W
B
LU
Problem
Possible cause
Solution
No sound.
VOLUME is not adjusted.
Adjust volume.
no power
Headphone is connected.
Disconnect headphone.
Mains cable is not securely connected.
Connect mains cable properly.
Batteries are flat
Insert fresh batteries.
Batteries are inserted incorrectly.
Insert batteries correctly.
Trying to change over from mains to
battery supply without removing the plug.
Remove the mains plug from the
unit's AC MAINS inlet.
No reaction to Electrostatic discharge,
operation of any keys
Disconnect the set from power supply,
reconnect after a few seconds.
Poor radio reception Weak radio signal.
Direct the antenna for optimum
reception.
Interference caused by vicinity of electrical
Keep the radio away from electrical
equipment like TVs, computers, engines, etc..
equipment.
no d ¡SC
or
The CD is badly scratched or dirty.
Replace or clean the CD.
Cd Err
indication
No CD is inserted.
Insert a CD.
The CD is inserted upside down.
Insert CD with label upwards.
The laser lens is steamed up.
Wait until the lens has cleared.
The CD skips tracks
The CD is damaged or dirty.
Replace or clean the CD.
SHUFFi£ or PROGHAM is active.
Switch off SHUFFi£ or PROGRAM play.
Poor cassette
sound quality
Oust and dirt on the heads, capstans or
pressure rollers.
Clean heads, capstans, and pressure
rollers.
Use of unsuitable cassette types
(METAL or CHROME) for recording.
Dniy use NDRMAL type cassettes for
recording.
Recording does
not work
Cassette tab(s) may be snapped off.
Apply a piece of adhesive tape over
the aperture.
Remote control does Batteries are inserted incorrectly.
Insert batteries correctly.
not function properly
(AZ1208 only)
Batteries are flat.
Insert fresh batteries.
Distance to the set is too large.
Reduce distance.
15