Philips CD 605 - Manual (Page 9)

PROGRAMMING ADDITIONAL INFORMATION
ERASING A TRACK FROM A PROGRAMME
(NEXT. PREVIOUS and PROGRAM)_____________
• Press NEXT or PREVIOUS, before or after
programmed play (STOP mode), until the number
you wish to erase appears under TRACK.
• Press PROGRAM within 8 seconds.
- The P after the number is replaced by a C (for
Clear).
- The number disappears from the display and from
the number indicator; it has now been erased.
ADDITIONAL INFORMATION
LISTENING WITH HEADPHONES (PHONES)
• Connect headphones with a 6.3 mm jack plug to
the PHONES socket.
- The sound level is adjusted with the VOL(ume)
control.
MAINTENANCE
The CDs
• Never write on the printed side of a CD.
• Do not attach any stickers to the CD.
• Keep the shiny surface of the CD clean.
Use a soft lint-free cloth and always wipe the disc
in a straight line from centre to edge.
• Never use cleaning agents for conventional
records.
• Detergents or abrasive cleaning agents should not
be used either.
The player
• A chamois leather slightly moistened with water is
sufficient for cleaning the player.
• Do not use cleaning agents containing alcohol,
spirits, ammonia or abrasives.
FAULTS AND THEIR LIKELY CAUSES
If a fault occurs, run through the points listed below
before taking your player for repair. Check whether:
- condensation has formed on the lens of the laser
due to a dramatic change in temperature; this will
disappear automatically after some time;
- the CD has been inserted correctly with the printed
side up and that there is a CD in the compartment;
- the CD is dirty, badly scratched or warped;
- the player has been connected to the PHONO
socket of the amplifier.
If the fault remains, try to clear it by switching the
player off and on again.
If this also fails to help, consult your dealer.
Under no circumstances shouid you repair the
piayer yourseif, as this wiil invaiidate the guaran­
tee!
TECHNICAL DATA
Typical Audio Performance
Frequency range: 20-20,000 Hz
Amplitude linearity: 0.035 dB
Phase linearity: 0.5° (20-20,000 Hz)
Dynamic range: 92 dB
Signal-to-noise ratio: 100 dB (A-weighted)
Channel separation: 95 dB
Total harmonic distortion: 0.0025%
D/A conversion: Bitstream conversion
(256 X oversampling, 1 bit)
Audio output level: 2
Impedance PHONES socket: 8-1000 ohms
Power supply
Mains voltage and frequency: see the type plate on
the rear of the player
Power consumption: 11 W approx.
Safety requirements: lEC 65
Cabinet
Material/finish: metal and polystyrene with decora­
tive trim
Dimensions (w >c h x d): 420 ;c 90 x 280 mm
Vl/eight: 3.8 kg approx.
Subject to modification
This Compact Disc piayer compiies with radio
interference requirements as iaid down in EC
reguiations.