Futaba GY701 Quick Start User Manual

Page 14

INISHING

Ensure that all extensions and servo wires are
attached and bundled within the helicopter and that
everything is plugged in correctly. Before the test
fl ight verify all settings and ensure that the gyro
compensates the proper direction.

Ensure that:
❑ the Transmitter and Receiver batteries are fully

charged.

❑ the gyro mounting pads are in good condition.
❑ the gyro wiring has some slack in it and all wires

are clear of the main frame.

❑ the GY701 servo type parameter matches the

servo you are using.

❑ the tail rotor servo arm is perpendicular to the

pushrod and the pitch slider is centered.

❑ the servo does not bind when full left or full right

tail rotor is applied.

❑ the gyro is operating in the correct mode (AVCS

or Normal).

❑ the tail rotor stick operates the tail rotor the correct

direction.

❑ the gyro compensates the correct direction when

the helicopter is rotated.

❑ the gain is set correctly and the gyro operates

in the correct mode (AVCS or Normal) in every
fl ight condition.