When using a t8usuper transmitter, Gy502 settings, Transmitter settings – Futaba GY502 User Manual

Page 26: Sensitivity display, Relationship between transmitter and gyro setting

ATA

ETTING

When Using a T8Usuper Transmitter

The Gyro Mixing (GYRO) function lets operator perform a gain adjustment at
each Idle-Up switch position.

[GY502 Settings]

Select the gyro operation mode at the GY502 Mode screen. (AVC, NOR, or
CMT)

[Transmitter Settings]

Gyro Mixing function:
1. Select the “ON” mode at the transmitter Gyro Mixing (GYRO) setup
screen.
2. Select the Idle-Up switch(SW-E) for the sensitivity selection.
3. Set the “NORM”, “IDL1” and “IDL2” gains.
(The following page shows a setting example in the CMT mode.)

[Sensitivity Display]

The gain display indicates the actual gain at the GY502 normal screen
display.

The following shows the relationship between transmitter and gyro setting
when GY502 sensitivity setting is 100% in both the G1 and G2 gain modes.

- Relationship between transmitter and gyro setting

Transmitter

settings

GY502mode

settings

Actual gain

NORM

IDL1
IDL2

NOR

AVC

CMT

0% - 50% - 100%

Normal mode

AVCS mode

Normal mode AVCS mode

(G2) (G1)

100% - 0% - 100%