Futaba 7UAF, 7UAP - Manual (Page 17)

• FUNCTION AND DATA SETTING
Press the [MODE SELECT] To normal display mode
Activate/inhibit mode setting
Set the mode with the
keys.
+ : Activate
-: Inhibit
Select the direction
Switch the RIGHT UP
DOWN LEFT
to the combination
of directions to be set.
Aileron servo throw setting
Set the flashing display to CH1
with the keys.
Set the rate with the
keys.
(When the + and — keys are
pressed simultaneously, 100% is
set.)
Elevator servo throw setting
Set the same as
Rudder servo throw setting
Set the same as
Set for each direction of the
by repeating steps to
SAFETY mode setting
Set the to CH5 with the
keys.
Set the to the
direction for which snap roll is
to be turned off (direction in
which landing gear is down).
Press the — side of the
keys.
SAFETY mode release
Set the to CH5 with the
keys.
Press the + side of the
keys.
ToDIFF
F: SAFETY mode released
5L: S A F E T Y mode set and
ON
5F: S A F E T Y mode set and
OFF
SNAP ROLL
UP RIGHT
LEFT DOWN
"1" to "4" is displayed
according to the
position.
1: R/U
2: R/D
3: L/U
4: L/D
• The SAFETY mode can be set.
(Mode in which operation is not
performed when the landing gear
is down even if the switch is turn-
ed on by mistake.)
• The throw of the channel 1 (ail-
eron), channel 2 (elevator), and
channel 4 (rudder) servos can be
set.
• Four snap roll directions can be
set.
R/U: Right up snap
R/D: Right down snap
L/U: Left up snap
L/D: Left down snap
(INH: Inhibit state)
SNP
SNAP-ROLL
Avalanche and other snap rolls can
be performed by switch.
- 15 —