Futaba 7UAF, 7UAP - Manual (Page 11)

• FUNCTION AND DATA SETTING
To REV
To F/S
Function Display Data setting
CH selection
Select the CH to which EXP is
to be applied with the
keys.
EXP
EXPONENTIAL
This function modifies the operat-
ing curve so that operation is easy
when the movement of the servos
becomes sluggish or sensitive near
the neutral position.
• E X P can be set for CH1 (aileron),
CH2 (elevator), CH3 (throttle),
and CH4 (rudder).
• The rate can be set for each direc-
tion of the
(However, there is no
for the throttle.)
•The rate setting range is —100%
(slow side) to +100% (quick side)
in 4% steps.
D/R switch direction selection
Switch to the direction to which
the
is to be set.
Rate setting
Set the rate with the
keys. (When the + and
- keys are pressed simultaneous-
ly, 0% is set.)
Set for a different CH and
direction by repeating steps
(Note) At initial flight, test at EXP 0%. Ad-
justment as desired in accordance with flight
is recommended.
Function Display Data setting
REV
REVERSE
Used when modifying servo direc-
tion of operation.
• Can be set for each channel.
N: Normal side
R: Reverse side
CH selection
Select the CH for which REV is
to be set with the
keys. (CH NO. flashes)
Direction of operation setting
Set the direction with the
keys.
+ : Normal
— : Reverse
Set for another channel by repeating steps
and
(Note) Be especially careful in the aileron
direction.
Press the [MODE SELECT] To normal display mode
-9-