Futaba 6YF - Manual (Page 20)

21
R
EFERENCE
Action
Replace the battery. Charge the
nicd battery.
Reload the batteries in the
correct polarity.
If the contact spring is deformed,
correct it.
Wipe with a dry cloth.
Screw in.
Extend fully.
Push in.
Match transmitter/receiver band.
Replace with specified crystal.
Reinsert.
Push in.
Separate from other wiring.
Request repair.
Install in accordance with
instruction manual.
Adjust at the fuselage side.
Install a noise absorbing
capacitor.
Troubleshooting
If your digital proportional R/C set does not operate, its range is short, it intermittently
stops operating, or it operates erroneously, take the action shown in the table below. If
this does not correct the trouble, please contact a Futaba dealer.
Check item
Dead battery.
Incorrect loading.
Faulty contact connection.
Dirty contacts.
Loose.
Not extended to full length.
Disconnected.
Wrong band.
Different from specification.
Incorrect wiring.
Disconnection.
Close to other wiring.
Not cut?
Not bundled?
Binding or looseness
Noise countermeasures.
Check point
Transmitter/receiver battery
Transmitter antenna
Crystal
Connector connection
Receiver antenna
Servo linkage
Motor (electric motor plane)
75 MHz Band: (car/boat only)
75.410 61 75.610 71 75.810 81
75.430 62 75.630 72 75.830 82
75.450 63 75.650 73 75.850 83
75.470 64 75.670 74 75.870 84
75.490 65 75.690 75 75.890 85
75.510 66 75.710 76 75.910 86
75.530 67 75.730 77 75.930 87
75.550 68 75.750 78 75.950 88
75.570 69 75.770 79 75.970 89
75.590 70 75.790 80 75.990 90