Futaba 6EX 2.4GHz - Manual (Page 10)

10
RECEIVER AND SERVO CONNECTIONS
Connect the servos to the receiver to perform the functions indicated:
Receiver
output
channel
Function
Aircraft (ACRO) Helicopter (HELI)
1
Aileron -or-right flaperon -or-right elevon (for tail-
less models)
Aileron
2
Elevator -or-left ruddervator (for V-tail models)
-or-left elevon (for tailless models)
Elevator
3 Throttle Throttle
4 Rudder -or-right ruddervator (for V-tail models) Rudder
5 Retractable landing gear Gyro sensitivity
6 Flap -or-left flaperon Pitch
B
Receiver on/off switch (the plug colored red
goes into the receiver) Receiver on/off switch (the plug colored red
goes into the receiver)
Switch
Harness
To Battery
Charging
Jack
(Black)
Aileron Servo
(CH1)
Optional
Gyro
System
Elevator Servo
(CH2)
Throttle Servo
(CH3)
Rudder Servo
Rudder (CH4)
Pitch Servo
(CH6)
The diagram shown is for helicopter models only. It is necessary to buy an additional gyro separately.
Gyro sensitivity (CH5)
Receiver
Switch
Harness
To Battery
Charging
Jack
(Black)
Aileron Servo
(CH1)
Elevator Servo
(CH2)
Throttle Servo
(CH3)
Rudder Servo
(CH4)
Gear Servo
(CH5)
Flap Servo
(CH6)
The diagram shown is for aircraft models only. Additional servos may have to be purchased separately.
(CH1)
(CH6)
(CH1)
(CH2)
(CH4)
(CH2)
(CH4)
Flaperon Mode (Dual Aileron
Servo, CH1 & 6)
Independent Aileron & Flap
(CH6)
(Red)
(Red)
Receiver
NOTE: NEVER use dry battery for R606FS
as it cause malfunction.
NOTE: NEVER use dry battery for R606FS
as it cause malfunction.