Set-up procedure when installed in a car) – Futaba 3PM-X 2.4GHz User Manual

Page 27

Text mode
Original mode

Initial Set-Up

(Set-Up Procedure When Installed In a Car)

When installing the servos in a car, performing function set-up in the following order
is recommended.

1. Set up the servo trims (page 26).

2. Set the servo direction of operation using the Reverse

function. (Page 49)
The servo installation method and linkage direction depend
on the kit. Therefore, the servo operation direction may have
to be reversed relative to transmitter operation. Before in-
stalling the servo, check the operating direction and set it us-
ing the Reverse function.

3. Set the subtrim and adjust the servo neutral point. (Page

48)

4. Set the trigger travel by adjusting the throttle trigger me-

chanical ATL to your liking. (Page 17)

5. Set EPA of each channel and adjust the servo throw

(travel). (Page 30)