Futaba 3PM-X 2.4GHz - Manual (Page 26)

26
Initial Set-Up
- Steering dual rate (DT3) check
At initial set-up, steering dual rate is assigned to grip lever DT3 (upper) at the grip of
the transmitter. Operate the DT3 lever and check if the D/R value displayed on the
screen changes. After checking D/R, set the steering dual rate to 100%.
- Throttle ATL (DT4) check
At initial setting, throttle ATL is assigned to grip lever DT4 (lower) at the grip of the
transmitter. Operate the DT4 lever and check if the ATL value displayed on the
screen changes. After checking ATL, set throttle ATL to 100%.
Steering D/R
value
Throttle ATL
position
DT3
DT4
- Steering trim (DT1) check
At initial set-up, steering trim is assigned to digital trim DT1 above the steering
wheel. Operate the DT1 lever and check if the steering trim value on the screen
changes. After checking the trim, set the trim value to the center (0) position.
- Throttle trim (DT2) check
At initial set-up, throttle trim is assigned to digital trim DT2 at the left side of the
steering wheel. Operate the DT2 lever and check if the throttle trim value on the
screen changes. After checking the trim, set the trim value to the center (0) position.
Throttle trim
position
DT2
DT1
Steering trim
position
3. Trims Initial Set-Up