Expert Sleepers USAMO v1.0.0 - Manual (Page 11)

Channelise
If set to “Off”, MIDI messages are sent out on the same channel on which they are
received. If set to a channel number (1-16), the incoming MIDI messages are sent out on
the specified channel.
Clock
If enabled, causes the plug-in to send MIDI timing clock messages, synced to the DAW’s
transport.
When Clock is enabled, MIDI clock is generated when the host DAW’s transport is
running. The MIDI clock generation always begins at the start of a bar; if the host transport
is started in the middle of a bar, the plug-in waits for the next bar before starting the MIDI
clock.
SPP
If enabled, the plug-in will send MIDI Song Position Pointer messages.
Swing
These controls allow you to add ‘shuffle’ or ‘swing’ timing to the clock output.
Swing has two controls. The knob sets the amount of swing, in percent. 50% means no
swing (the middle sixteenth note is 50% of the way between the neighbouring notes, as
normal). Higher values of swing make the middle note later; lower values make it earlier.
At 100%, the middle note is right on top of the following note.
The dropdown menu chooses between sixteenth and eighth note swing.
Offset
The Offset control applies a small delay or advance in the timing of the MIDI clock,
relative to the host’s transport. This can be used to compensate for any difference in the
response time of the hardware being synced.
Don’t Panic
The Don’t Panic button sends a MIDI All Sound Off message on all 16 MIDI channels. This
should deal with any stuck notes or other bad state if it occurs.
!11