Chief Manufacturing CM6DH - Manual (Page 7)

Installation Instructions CM6DH SERIES
7
Hanging and Adjusting Doors
1. Remove door hanger from mechanism by removing locking
screws and washers. (See Figure 3)
Figure 3
2. Center door hanger to top of door and secure with eight flat
head screws of sufficient length to support weight of door.
(See Figure 4)
Figure 4
3. Attach one guidewheel plate (F) to bottom center of each
door. (See Figure 5)
Figure 5
4. Move carriages to one half open position by activating
mechanism and pressing button a second time when
carriage reaches desired position. (See Mechanism
Activation section).
5. Lift door and engage guidewheel into guidewheel space.
6. Tip top of door in, engaging the pendant bolts into keyhole
in carriage arms. (See Figure 6)
Figure 6
7. Adjust height and alignment of doors by turning the pendant
bolts. (See Figure 7)
8. After adjustment is complete, replace the washers and
locking screws. (See Figure 7)
Door
Hanger
Locking Screws
and Washers
x 8
(F) x 2
6
Pendant
Bolts
Keyhole