Envirco MAC 10 LE-AC - Manual (Page 7)

MAC 10 LE-AC SERVICE MANUAL
6 E G A P
Figure 2 – Foam Prefilter Cleaning
3 SERVICE: Cleaning the MAC 10 LE-AC Prefilter (G4 Pleated
Prefilter)
WARNING!
Disconnect the unit from the electrical power source before attempting any
service.
Tools Required: None
Note: To keep the filter in top operating condition replacing the pleated prefilter is
recommended every twelve months or sooner.
Step 1. To gain access to the prefilter, remove the ceiling panel next to the unit, if
applicable.
Step 2. Switch the ON-OFF switch to the off position.
Step 3. Remove the prefilter from the snap-in frame. The beverage frame has slots
that have to be depressed to release the filter from the prefilter housing (See
Figure 3)
Step 4. After removing the new G4 pleated prefilter from the box, remove the die cut
slots from the beverage board frame and install on prefilter bracket.
Step 5. Reassemble by reversing the above steps.
Figure 3 – G4 Prefilter Replacement
ON/OFF Switch