Envirco MAC 10 LE-AC - Manual (Page 2)

MAC 10 LE-AC SERVICE MANUAL
Critical operation conditions of the MAC 10
1. Touching of the HEPA filter will damage it, voiding the warranty on the
filter. The screen is only to protect against an accidental ‘touch’ of the
filter. Never place a hand or tool on the filter. Never lie filter face flat
down on a surface always have filter on its side or back to protect from
damage.
2. Prior to powering the unit, verify that the unit has been plugged into the
correct voltage. The serial number label on the top of the Mac 10 unit has
the required voltage.
3. For reorder prepossess the Mac 10 part number and serial number
should be recorded. This information is located on the serial number
label, located adjacent to the electrical box. If you can’t located the Sales
Order Number please contact Envirco for this information.
Part Numbers Covered by this Manual
Note: A ‘Z’ in the part number indicates that the unit is special. This may
indicate a size change from standard or a special filter. Please contact
the factory for part numbers if this is the situation.
CAUTION
TO REDUCE THE RISK OF INJURY TO PERSONS, INSTALL FAN AT
LEAST 2.1M (7 FEET) ABOVE THE FLOOR
11194-XXX Mac 10 LE AC 2x4 (600x1210mm) Standard Filter
Mac 10 LE AC 2x4 (600x1210mm) RSR/E Filter