Empress Effects Phaser - Manual (Page 12)

Controls at a Glance
power: 9V - 18V DC negative
tip 2.1mm jack. 120mA or greater
- +
blend: controls the mix between the original signal
and the phase-shifted signal. Fully clockwise will
result in the deepest phase cancellations
speed/ratio: with the mode switch set to tap, this knob
sets the multiplication ratio for the tapped tempo.
With mode set to knob, this controls the speed of the
phaser
mode: set to control the speed with either tap or
knob. Select auto mode to use the audio input to
control the phaser dynamically
speed range: controls the range of speeds available
on the speed/ratio knob
stages: selects the number of all-pass poles. The
2-pole setting sounds the least effected, 4-pole is
the setting you’ll find in most one-knob phasers, and
3-pole sounds quite different from both
tap stompswitch: use to set the speed of the phaser.
Tempo will be multiplied by the current setting on the
ratio knob
*
these controls are for tap and knob modes. Auto mode uses the controls marked with inverted text. These are outlined in the auto mode section