Connections, Operation – Emerson Radio EK215 User Manual
Page 6
5
CONNECTIONS
CONNECTING THE UNIT TO A HOME STEREO
From
Aux
Out
To
Aux In
RECEIVER OR HOME STEREO
NOTES FOR CONNECTING TO A
RECEIVER/HOME STEREO:
• Connecting the unit to a receiver/home
stereo will allow you to broadcast the
unit’s sound through the receiver/home
stereo's speakers.
• When connecting the unit, refer to the
owner’s manual of the receiver/home
stereo, as well as this manual.
• When connecting the unit, make sure the
power is off and both units are unplugged
before making any connections.
CONNECTING THE MICROPHONE(S)
This unit has two microphone jacks, use with the supplied microphones which will allow you to sing along
with your favorite songs. Before connecting, make sure the MIC VOLUME control is set to minimum.
If only connecting one microphone, connect it to the MIC A jack.
HEADPHONE JACK
For private listening, connect low impedance 3.5mm (32 ohm) stereo headphones (not included) to this jack.
The speakers are automatically disconnected when the headphone plug is inserted in the jack.
OPERATION
Rotate the ECHO control clock-
wise to increase the echo or
counterclockwise to decrease the
echo.
1
ECHO CONTROL
Rotate the TONE control clock-
wise to increase the higher tone
response.
1
TONE CONTROL
To turn the microphone on, slide
the ON/OFF switch, located on
the side of the microphone, to the
ON position. To turn the
microphone off, slide the ON/OFF
switch to the OFF position.
1
MIC ON/OFF SWITCH
EK215 KARAOKE O/M.QXD 8/15/02 3:42 PM Page 5