Ecler VERSO P - Manual (Page 9)

9
7. OTHER CONSIDERATIONS
Ground loops: Ensure at all times that the signal sources reaching the unit and all the
devices connected to its output do not have interconnected grounds, i.e., they should not be
connected to ground through two or more different routes, since this could cause buzzing that would
affect the sound reproduction quality. If cable shielding are connected to the chassis, they should be
never interconnected, in order to avoid ground loops.
Audio connections: As a general rule, try to ensure that the signal connections are as
short as possible and use the best quality connectors and cables. Poor quality of the connections
and/or cable used could lead to an important deterioration of the sound reproduction quality. The
Ecler catalogue contains the necessary cabling references.
Background noise: The use of active short-circuitry will product a more or less high level
of background noise, depending on the configuration. The VERSO P series has been designed to
reduce background noise level to a minimum. In all cases, it should be mentioned that the noise level
obtained is directly dependent on the quality of all the elements connected in the installation, and the
correct installation and use thereof.
Cleaning: The front panel should not be cleaned with dissolvent or abrasive substances
because silk-printing could be damaged. To clean it, use a soft cloth slightly wet with water and
neutral liquid soap; dry it with a clean cloth. Be careful that water never gets into the unit through the
holes of the front panel.