Chicago Electric Flexible Shaft Grinder/Carver 40432 - Manual (Page 9)

Page 9 For technical questions, please call 1-800-444-3353. SKU 40432
General Operating Instructions
TO pREVENT INjuRY
FROM BuRNS:
With normal use, the motor
housing (7) will get hot. This is
normal and not harmful to the
tool. However, the hot surface of
the housing may be harmful if
touched or present a danger if it
is within three (3) feet of
flammable material. If the tool is
used for a prolonged period of
time and if the housing becomes
EXTREMELY HOT, stop using the
tool until the unit cools off. Also
the Chuck housing will become
warm. If it becomes
uncomfortable to hold, rest the
tool and allow it to cool down.
Before using this tool, make sure that 1.
clothing, hair and work pieces are out of
the way of the Hand Piece and the Bit.
Turn the tool ON.
Adjust tool speed by pressing on the
2.
Foot Control (27).
If the Flexible Shaft (21) does not
3.
operate properly, inspect the connections
to the Flexible Shaft.
To prevent accidents, turn off the tool
4.
and disconnect its power supply after
use. Clean, then store the tool indoors
out of children’s reach.
REV 04c, 04l, 08l, 09c, 09e