Dynaflite GPMA1052 Bird of Time - Manual (Page 12)

❏
6. Put the 1/16" [1.6mm] ply strip across the
servo. Drill a pilot hole through the ply and into
the hardwood block at each end of the ply strip.
Use two #2 x 3/8" [9.6mm] sheet metal screws
to hold the ply strip in place.
❏
7. Secure the servo cover to the fuselage with
a clear tape circle (cut from a leftover clear area
of the decal sheet using the template provided
on page 17).
❏
1. Install your receiver. The photo shows a
Futaba R114F 4-channel receiver. Use 1/4"
[6.4mm] foam or double-sided foam tape to
protect the receiver and hold it in place. Note:
The receiver can also be mounted in the nose if
required for balancing the model.
❏
2. Route the receiver antenna to the second
tube in the fuselage. Push the antenna into the
tube making sure the antenna goes down the full
length of the tube.
❏
1. Cut the canopy along the cut lines and fit it
to the fuse. The canopy can be held in place
with clear tape or #2 x 3/8" [9.6mm] screws.
Note: If you are concerned with the drag of an
external switch and charge plug, the canopy
can be installed using the included ply
mounting plate. Glue the canopy to the ply
plate and then use small rubber bands and cup
hooks (not included), as shown in the photo
above, to hold the canopy in place.
Final Assembly
Install the Receiver
12