Cabletron Systems 9E423-36 - Manual (Page 8)

9E423-36 Module Specific Information
6
Setting One Port to Full Duplex
To set one Ethernet port to Full Duplex (for example, port 1):
1. Use the arrow keys to highlight STANDARD ENET in the Operation Mode
field (to the right of port 1).
2. Press the Space Bar until FULL DUPLEX appears in the field.
3. Use the arrow keys to highlight the SAVE command on the bottom line of the
screen.
4. Press the Return key.
Setting All Ports to Full Duplex
To set all 36 Ethernet ports to Full Duplex:
1. Use the arrow keys to highlight the SET ALL PORTS field.
2. Press the Space Bar until you see FULL .
3. Use the arrow keys to highlight the SAVE command on the bottom line of the
screen.
4. Press the Return key.
Displaying Information About Other Ports
To display information about other ports:
1. Use the arrow keys to highlight [1-12] (for the first 12 ports), [13-24] (for the
next 12 ports), or [25-36] (for the last 12 ports) at the bottom of the Full Duplex
Configuration Screen.
2. Press the Return key.