Drawmer MX40 Pro Quad Channel Punch Gate - Manual (Page 3)

DRAWMER MX40
Quad Punch Gate
SAFETY CONSIDERATIONS
C AUTIO N - M AIN S FU SE
TO REDUCE THE RISK OF FIRE REPLACE THE MAINS FUSE ONLY WITH
THE SAME TYPE, WHICH MUST BE A CLASS 3, 230 VOLT, TIME DELAY
TYPE, RATED AT 63mA WHERE THE MAINS INPUT VOLTAGE SWITCH IS
SET TO 230 VOLTS AC. AND 125mA WHERE THE MAINS INPUT VOLTAGE
IS 115 VOLTS AC.
ALL FUSES MUST COMPLY WITH IEC 127-2.
THE FUSE BODY SIZE IS 20mm x 5mm.
CAUTION - MAINS CABLE
DO NOT ATTEMPT TO CHANGE OR TAMPER WITH THE SUPPLIED MAINS
CABLE.
CAUTION - SERVICING
DO NOT PERFORM ANY SERVICING. REFER ALL SERVICING TO
QUALIFIED SERVICE PERSONNEL.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE.
INSTALLATION
The MX40 is designed for standard 19" rack mounting and occupies 1U of rack
space. Avoid mounting the unit directly above power amplifiers or power supplies
that radiate significant amounts of heat. Always connect the mains earth to the unit.
Use fibre or plastic washers to prevent the front panel becoming marked by the
mounting bolts.
3