beautypg.com

Dodge 2009 Ram 1500 User Manual

Page 178

background image

2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)
from the HomeLink

௡ buttons while keeping the EVIC

display in view.

For optimal training, point the battery end of the hand-
held transmitter away from the HomeLink

3. Simultaneously press and hold both the chosen
HomeLink

௡ button and the hand-held transmitter button

until the EVIC display changes from “CHANNEL #
TRAINING” to “CHANNEL # TRAINED”.

Then release both the HomeLink

௡ and hand-held trans-

mitter buttons.

If the EVIC display states “DID NOT TRAIN” repeat
step 3. If the signal is too weak, replace the battery in the
original hand-held transmitter.

It may take up to 30 seconds, or longer, in rare cases. The
garage door may open and close while you train.

NOTE:

Some gate operators and garage door openers

may require you to replace Step 3 with procedures noted
in the “Gate Operator/Canadian Programming” section.

4. Press and hold the just-trained HomeLink

௡ button. If

the channel has been trained, the EVIC display will now
state “CHANNEL # TRANSMIT”.

If the EVIC display still states “CHANNEL # TRAIN-
ING” repeat Step 3.

NOTE:

After training a HomeLink

௡ channel, if the

garage door does not operate with HomeLink

௡ and the

garage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so, proceed
to the heading “Programming A Rolling Code System.”

5. PROGRAMMING A ROLLING CODE SYSTEM
At the garage door opener motor (in the garage), locate
the “learn” or “training” button.

176

UNDERSTANDING THE FEATURES OF YOUR VEHICLE