beautypg.com

Using homelinkĥ, Using homelink – Dodge 2012 Ram User Manual

Page 199

background image

3. Simultaneously press and hold both the Homelink

button while you press and release (“cycle”), your hand-
held transmitter every two seconds.

4. Continue to hold buttons until the EVIC display
changes from “CHANNEL # TRAINING” to “CHAN-
NEL # TRAINED”, then release both buttons.

NOTE:

• It may take up to 30 seconds or longer in some cased

for the channel to train.

• If the EVIC displays “DID NOT TRAIN” repeat from

Step 2.

5. Press and hold the programmed HomeLink

௡ button.

The EVIC will display “CHANNEL # TRANSMIT”. If the
device is plugged in and activates, programming is
complete.

If you unplugged the garage door opener/device for
programming, plug it back in at this time.

Reprogramming A Single HomeLink

Button

To reprogram a channel that has been previously trained,
follow these steps:

1. Turn the ignition switch to the ON/RUN position.

2. Press and hold the desired HomeLink

௡ button until

the EVIC displays “CHANNEL # TRAINING” Do not
release the button.

3. Without

releasing

the

button

proceed

with

“Canadian/Gate Operator Programming” Step 2 and
follow all remaining steps.

Using HomeLink

To operate, press and release the programmed
HomeLink

௡ button. Activation will now occur for the

programmed device (i.e., garage door opener, gate opera-
tor, security system, entry door lock, home/office light-
ing, etc.,). The hand-held transmitter of the device may
also be used at any time.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

197