Dodge 2013 Challenger SRT8 User Manual

Page 187

1. Turn the ignition switch to the ON/RUN position.

2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm)

away from the HomeLink® button you wish to pro-
gram.

3. Simultaneously press and hold both the Homelink®

button you want to program and the hand-held trans-
mitter button.

4. Continue to hold buttons until the EVIC display

changes from “CHANNEL # TRAINING” to “CHAN-
NEL # TRAINED”, then release both buttons.

NOTE:

• It may take up to 30 seconds or longer in some cases

for the channel to train.

• If the EVIC displays “DID NOT TRAIN” repeat from

Step 2.

5. At the garage door opener motor (in the garage),

locate the “LEARN” or “TRAINING” button. This can
usually be found where the hanging antenna wire is
attached to the garage door opener/device motor.
Firmly press and release the “LEARN” or “TRAIN-
ING” button. On some garage door openers/devices
there may be a light that blinks when the garage door
opener/device is in the LEARN/TRAIN mode.

NOTE:

You have 30 seconds in which to initiate the next

step after the LEARN button has been pressed.

6. Return to the vehicle and press the programmed

HomeLink® button twice (holding the button for two
seconds each time). The EVIC will display “CHAN-
NEL # TRANSMIT”. If the garage door opener/device
activates, programming is complete.

NOTE:

If the garage door opener/device does not acti-

vate, press the button a third time (for two seconds) to
complete the training.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

185