Dangerous Music Additional Switching System - Manual (Page 27)

25 | DANGEROUS MUSIC
•Using a #2 phillips head screwdriver, remove the four #6-32 x 1/4” black screws in the rear plate
(5).
Tip:
,
Put the screws somewhere where they won’t roll into the shag carpet like a recycled Trader Joes
Salsa Cruda container. You’ll need these in a minute.
STEP 4. Installing the board
•Where you just removed the rear panel, slide the board and rear panel assembly (1) through the
rectangular opening.
•Attach it to the rear with the four #6-32 x 1/4” black screws removed from rear blank (5).
•Screw board down (13) with four #6-32 x 3/8” machine screws (3).
•Attach the DAC-ST face (2) with the four #4-40 x 1/4” silver screws removed from the front blank
(4).
STEP 5. Wiring the goods
•Before attaching the 20 pin larger IDC ribbon cable (7), orient the A.S.S. exactly as in the prior
photo op and note the red trace, indicating pin 1. Now, connect the ribbon cable to the DAC-ST
PCB (11) with the red trace on the left. Then, connect it to the control PCB (15) with the red trace
on the lower half of the ribbon. Note the gentle fold in the ribbon.
•Before attaching the 12 pin smaller flat ribbon cables (6) orient your A.S.S. exactly as in the prior
photo op. Now, noting the blue side of the ribbon connector, connect them between main (12) and
front PCB’s (16).
• Attach the 2-pin Molex connector extending from the front panel PCB (2) to the 2-pin header on
the Main PCB (15). It will click into place.
STEP 6. Clean up
•Screw the lid back on with those 8 black screws you put in the Salsa container.
•You’re done! Do a little victory dance and crack that beer now.
Tip:
,
If you are uncomfortable performing the installation yourself, Dangerous can perform it safely for
you at the factory.