Chrysler 2011 300 SRT - User Guide - Manual (Page 70)

OPENING THE HOOD
• Pull the hood release lever located on the
instrument panel, below the headlight switch.
• Raise the hood and locate the safety catch
lever, in the middle of the hood opening.
• Move the safety latch while lifting the hood
at the same time.
• Insert the support rod into the slot on the
hood.
• To close the hood, remove the support rod
and place it in the retaining clip, then lower
the hood slowly.
WARNING!
Be sure the hood is fully latched before driving your vehicle. If the hood is not fully latched,
it could open when the vehicle is in motion and block your vision. Failure to follow this
warning could result in serious injury or death.
MAINTAINING YOUR VEHICLE
68