Notes before starting operation – Toshiba SL39N Series User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6. LEVEL ADJUSTMENT
Correct
Incorrect
Set the scale on a stable and level surface. Level the scale by turning the
adjusting legs so that the air bubble comes to the center circle. For
example, in the case of the condition shown in the left figure, turn the
Adjusting Legs (1) and (2) in the direction shown so that the bubble
comes to the center of the circle.
)
,<2)
7. NOTES BEFORE STARTING OPERATION
A. Be sure to insert power plug into AC outlet.
B. When turning IPOWER/ZEROI key on within about 16 seconds after inserting the power plug into AC
outlet, the scale enters the test scanning sequence, such as 00000, 0000, 00000, then 11111, 1111,
11111 ... until ZEROS are shown on all displays.
C. While scale is in the test sequence, do not put anything on the platter.
D. Do not move the unit while it is in operation. Should it become necessary to move it at any time, turn
the power switch off and be sure to readjust the level after relocating the scale.
E. Should a power failure occur during operation, turn the power OFF and remove the commodity from
the platter, and turn the power on again when power is restored.
F. If scale is used with an unrated power source, inaccurate scaling or other errors may occur.
G. If Zero Point has shifted during scaling, and no tare is displayed, adjust Zero Point by depressing
IPOWER/ZERQ] key.