Cleaning the print head – Toshiba TEC SL57 SERIES User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6. LEVEL ADJUSTMENT
Correct
Incorrect
Set the scale on a stable and level surface.
Level the scale by turning the adjusting legs so that the air bubble comes to
the center circle. For example, in the case of the condition shown in the left
figure, turn the adjusting legs (1) and (2) in the direction shown so that the
bubble comes to the center of the circle.
)
• (
2
)
7. CLEANING THE PRINT HEAD
If the print head is dirty, clear printing is not performed. It is recommended to clean the head with thermal
head cleaner everyday, before starting operation by following procedure:
1. Remove the printer cover and side cover. Then
pull the head-up lever to arrow direction.
2. Wipe off the dirt on the [■ portion] with the
thermal head cleaner.
Then set the label, and push down the print
head.
NOTE: Do not damage the print head when
cleaning.
- 7 -