KORG Concert 800 - Manual (Page 11)

U s i n g M u l t i - M o d e P l a y
The term ’’multi mode” refers to the ability to play two or more ’’parts” simul­
taneously.
It is often used with a sequencer or computer for automatic play-
It is also possible to manually play one of the parts at the same time on the key­
board. (When multi mode is not selected, the unit is said to be in single mode. )
(^Two out of the C-800’s five timbres can be selected at a time (except PIANO &
STRINGS), and one of these two may be played on the keyboard.
d)An additional timbre can be added with the Symphony orchestra module, etc., for a
total of three, and any one of these may be played on the keyboard.
S e l e c t i n g M u l t i M o d e ________________________________________
To automatically Enter Multi Mode when Power Is Turned on
©Connect the Concerto to the C-800 as shown below.
(Be sure to turn off power on both units first. )
(DSet the mode switches on the Concerto rear panel as shown at the right. (This sets
up the Concerto for proper operation and also informs the C-800 that it should
enter multi mode when power is turned on. )
(DTurn on the power to the Concerto.
©Turn on the C-800. (After a few seconds
delay, all the LEDs will blink three times. )
MODE SW
L
”1 ' m
1 2 3 4 5
OFF
ON
To Manually Change from Single Mode to Multi Mode.
©Set up the C-800 and the Concerto (or another seqencer) as in © above.
(Not necessary to turn off power. )
(2)Set the Concerto mode switch as in (2) above.
(DPress the PIANO & STRINGS switch while holding down the MIDI/TRANSPOSE switch.
T h e C — 8 0 0 i s n o w i n m u l t i m o ; d :e ,
★When in multi mode, pressing the MIDI/TRANSPOSE switch causes the PIANO & STRINGS
light to flash continuously.
★Pressing the PIANO & STRINGS switch while holding down the MI DI/TRANSPOSE switch
returns the C-800 to single mode, extinguishing the light.
-
10
-