Installation to wood joist ceilings, A warning, Oa warning – Epson ELPMBPJF User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation To Wood Joist Ceilings
Drill two 5/32" (4 mm) dia. holes to a minimum
depth of2.5" (64 mm). Attach ceiling plate (G)with
two #14x 2.5" (6 mm x 65 mm) wood screws (F)
as shown using 3/8" (10 mm) socketwrench.
Skip to step 2.
o
A WARNING
Tighten wood screws (F) so that wall plate (G) is
firmly attached, but do not overtighten. Overtighten
ing can damage the screws, greatly reducing their
holding power.
Never tighten in excess of 80 in • lb (9 N.M.).
Make sure that mounting screws are anchored into
the center of the studs. The use of an "edge to edge"
stud finder is highly recommended.
A WARNING
It is the responsibility of the installer to verify that the
supporting surface will safely support the combined
load of all attached hardware and components.
IMPORTANT: Be sure to drill holes into thejoist CENTER!
5 o f 1 0
ISSUED:01-23-07 SHEET #:055-9498-4 05-20-10
For Technical Support Contact Peerless Mounts at 1-800-729-0307 or708-865-8870.