Uniden BEARCAT UBC100XLT - Manual (Page 8)

Operation
TheUBC lOOXLThas 100 memcryciiannels, eacnofwhicn can deprogrammed to
srore one irequenc/. The channeli are divided into 10-10 channel oanks, useful
for srcring similar frequencies m order to maintain faster scanning cycles, '''l/hen
scan is pressed, eacn of the prcgrammed frequencies within a selected dank will
de sampled for a transmission [locked channels will de skipped) at the race of
about i 5 channels per second. Ifanaaive frequency is found the unitwiil step and
monitor that frequency untif there is no longer any activity. A pa / o second delay
can be added to each channel and will allow the unit to monitor the frequency for
a .'“eturn or continued transmission. If, after two seconds, the frequency remains
inactive, the scanning cycle will resume.
When the unit is first turned cn, each channel will contain ‘CGG.GCO'. When new
frequencies are prcgrammed, the old will oe erased. If an invalid freouenc/ is
entered, "Error" wii) de displayed and the old frequency will return. ”
To operate the scanner maKe sure that the darterles are chargeq or cower .s
ccrrectiy connected to the unit. Turn the volume control on and adjust the desired
level. Adjust the squelch by turning the knee fully clockwise until a rusning sound
is heard. Turn the .kneb Pack until the receiver .s silent. After the channels have
been programmed, operation is simoie. .^ress the scan key to scan all the c.nanneis.
While the receivei" is scanning channels, pressing one of the numcer .kevs will turn
a bank of 10 channels on or off. The black lines at the top of the „CD display show
/cu wmeh banks are selected. If a bank s already selected, [shewn by a oiack line
uncer the dank numner] pressing tne corresconcmg burton will deselect that
bank. Press the manual key to stop scanning. Peceateoly pressing the manual key
will step through the channels in ordei'. ”
LCD Display
The L'8C ICGXLT has a backlit display wnich shews the current channel and
irequenc/ as well as ocher operationai mcdes. When the unit is scanning, the
channel number will racidly advance wmle the frecuency dispiav will go blank.
When the scanner is stepped the current cnanne! and frequency will again oe
displayed.
"
When frequences are programmed the d iso lay will shew the digits as they are
entered. The disolay will aiso snow "PRI" when the cncriry mode is on. "UfO'
whenever a cnannei appears that has been locked out. and "DLT' wrenever a
channel nas been prcgrammed for delay. ,^.crass the top of the disciay, a senes of
dashes under the numbers I-iO will be present. These are tne oani< maicator
numcers. These are selected or deselected during the scan seouence by the use of
the numeric oad.
’ ,